I've created a neat little door for my Mountain fortress but I've run into one small problem. The door only works in for one person at a time.
When I flip the lever on the outside to open the door it works fine, then once in the door I flip the lever and it closes fine.... and if I flip the lever to go back out it works fine.... The problem is if I go through the door and flip the lever to close the door behind me it works great until someone tries to open it from the outside again.... it won't open.
I have an mcEdit schematic of the door if that helps... just don't have it posted anywhere to provide a link as of yet.
When I flip the lever on the outside to open the door it works fine, then once in the door I flip the lever and it closes fine.... and if I flip the lever to go back out it works fine.... The problem is if I go through the door and flip the lever to close the door behind me it works great until someone tries to open it from the outside again.... it won't open.
I have an mcEdit schematic of the door if that helps... just don't have it posted anywhere to provide a link as of yet.
Create an account or sign in to comment.
1
1
I believe the error lies in the levers - one is probably still turned on, while you deactivate the other. So either use buttons, make them deactivate the lever, or tell them to watch out for that.
Unless we are talking about some entrance design, and not regular doors? But the issue is probably the same - one lever is activated
If you are certain both are off and they aren't triggering any other redstone at the door, I think it's best to submit the shematic.
Unless we are talking about some entrance design, and not regular doors? But the issue is probably the same - one lever is activated
If you are certain both are off and they aren't triggering any other redstone at the door, I think it's best to submit the shematic.