Hello There
this is my first project.
Its for PVP maps that involve capture points
essentially, its just a two way capture point. You stand on the center, and the switch controls the side the capture point "captures" for
command blocks and and outputs are located below the top
mechanism size is 15 X 11 X 15 (xyz)
Features:

• 2-way capture points
  
• 5 "levels" of capture on each side
  
• easy timer adjustment
  
• up to 1 second to 4 second delay on each level
  
• requires input after delay to count (no sneaky run past it and capture)
  
• variable input change after capture begins (so defend the switch well, or else you may just capture for the wrong side)
  
• Outputs located on external orange and pink wire
  
  

if you use or like the device, please diamond me :)
and i would like credit if you use, but i don't require it (would be really really nice though), nor do i require permission
Enjoy!

Note: it looks empty because i removed all unnecessary blocks

Additional Notes

Texture Pack used Ocd pack from FVDisco
inspiration Sethbling's & Hypixel's TF2 map

How it works
stepping on the pressure plate starts a clock. the clock delay circuit is below in a ring
the ring goes to a 2-way feed tape.
the pressure plate also allows use of the edge detectors below.
if the pressure plate is not pressed after delay, the edge detectors will not trigger.
Once the feed tape reaches the last block, it shall send a signal to stop the edge detector of that side only.
outputs are located on this line as well