Working Train Collection And Tools

There are redstone device tools displayed on this map that will assist you on building your very own working train stations.

There are 6 train design template you can choose from:

1. Bullet front, flat back (saved in structure block as t1)
2. Bullet front, round back (t2.1)
3. Bullet front, additional cart (t2.2)
4. Bullet front, additional stripe (t1.3)
5. Round front (t1.4)
6. Flat front (t1.5)

There are 3 + 2 modes of train:

1. State of train, viewed out of the train (t1 and t2)
2. State of train, where the Doors open of the right side of the train, where player has excess to enter the train (t3, t4)
3. State of train, where the player is inside of the train (t5, t6)
   
   
4. State of train, where the Doors open on the left side (for the station where the platform is on the left side of the train) (t3r, t4r, r as in reverse)
5. State of train, where doors on both sides are open (for the station where there are platforms on both side of the train) (t3b, t4b)

The train is saved in two sections (t1, t2) because the limit for saving structures in structure block in java is maximum 48blocks, and my train design exceeded the block limit. You can save it in one piece if your train is smaller than 48blocks.

Customizing Train:

You can change the design of the train, and make your own custom train! Change color, change front, back cart design, make it bigger or smaller, rearrange bench to make new design! But make sure to save your train on structure block as t1, t2, t3, t3r, t3b, t4, t4r, t4b, t5, and t6, or you would have to painstakingly change all the names to the names you saved it as, on the structure blocks of the redstone devices to load your train. Make sure the size of your train is no bigger than 85blocks, and you have at least 11blocks of train rail at the end of the train.

You can easily build the train track and train station by copy and pasting the redstone device tools, and arranging and assembling them together: Some of the tools were to big to be saved in the structure blocks, so they are saved as schematics. Use Worldedit mod to load, copy and paste the schematics. Transfer the content inside the schematics file to your schematics file to load the content: If you have the Worldedit mod, go to Roaming -> .minecraft -> config -> worldedit ->schematics. You could also just save the structures on the map using command //copy -e after pinning the position, and then load it and paste it as //paste -e (this command copy and paste entity as well).

To paste entity on the structure block, just press entity button on lower right corner to load it as well.