Published Jun 1st, 2014, 6/1/14 4:10 pm
- 319 views, 1 today
- 11 downloads, 0 today
3
Ultra Hard-Core Compatible Set-Up Schematic
I made this to give everyone the chance to play Ultra Hard-Core with their friends and set it up easily! Without hassling over all the commands and such, i simplified it into one large box! In this schematic, it will be compatible with any world it touches! It will literally set up the game for you and all you have to do is basically nothing! (compared to what the box is doing)
I made this to give everyone the chance to play Ultra Hard-Core with their friends and set it up easily! Without hassling over all the commands and such, i simplified it into one large box! In this schematic, it will be compatible with any world it touches! It will literally set up the game for you and all you have to do is basically nothing! (compared to what the box is doing)
What the box can do:
Can set-up up to 10 teams
Can add a variety of different numbers of players to each team
Have a customizable switch for natural regeneration and eternal daylight
Can display everyone's health to the right side of the screen
Can spread players throughout the map, still group them into teams
Gives a 60 second plan period where players can't break or build
Starts the game! with a mark every 20 minutes
A whole lot more that yet to be discovered
Can set-up up to 10 teams
Can add a variety of different numbers of players to each team
Have a customizable switch for natural regeneration and eternal daylight
Can display everyone's health to the right side of the screen
Can spread players throughout the map, still group them into teams
Gives a 60 second plan period where players can't break or build
Starts the game! with a mark every 20 minutes
A whole lot more that yet to be discovered
What the box can't do:
Load the map
Set up the map border
Nothing else, I swear
Instructions to Start the Ultra Hard-Core:
1. Load a new world
2. Load all the chunks from (-1000,-1000) to (1000,1000)
3. Close the world
4. Open the world on MCEdit (WorldEdit may work but will cause a lot of lag)
5. Set up the border with bedrock outlining the 1000s around 0,0
6. Set up the schematic outside of the border
7. Move your player and spawning point near the schematic
8. Save and close MCEdit
9. Open the world
10. type /setworldspawn near the box
11. Invite your friends to play
12. Go in the box and do what it says to set it up!
Future Updates:
Add a world border (1.8)
Notes:
The border has to be in the 1000s or greater, it can't be less
you don't have to add a border but make sure the spawn area is protected.
| Progress | 100% complete |
| Tags |
2627937
2
BroccoliTheGirl
CrystalRuby
cadbane86140
hotsuop
Mister_Lee
deadoppossum11
PunkYeen
_SoleWalk_
Friends_cats_oficial_YT
C4RLOZ
GlitchMrTyperOfCommands9301
miloszd2009
Create an account or sign in to comment.